Now, THIS is a brilliant way to shade your backyard on the cheap!

I know that my mom likes sitting outside, but she always comes in pretty fast just because the sun would beam down on her. I guess I never really paid attention to the heat and sun because I was so used to it and sunscreen is my best friend. I needed something that could go in our backyard that wasn’t expensive because I still want to build a backyard kitchen and need to save for that. I also wanted something that looked a little better than the last set I made for her. Here is my DIY Backyard Sunshade that completely blocks the sun for her and now she can watch the kids play without having to rush inside. It only took about an hour to complete and it turned out better than expected. Enjoy!
  • diy backyard sunshade, diy, gardening, how to, outdoor living
What I Used: 4 Rebar Posts (We made sure that the rebar fit into the pvc), 4 Full Length- ½” PVC Conduit (Gray), 1- ½” PVC Conduit (White, Cut to the width desired for sunshade), ½” Conduit Tee Fitting, 2 Curtains, 4 Terra Cotta Pots, Flowers
  • diy backyard sunshade, diy, gardening, how to, outdoor living
My husband placed the rebar into the ground according to where the ends of the full length pvc would sit.
  • diy backyard sunshade, diy, gardening, how to, outdoor living
The rebar is used to support the pvc. The full length pvc has a male and female end and initially I stuck two of them together to make one arch, but it wasn’t sturdy enough going across and the arches were bending to the sides.
  • diy backyard sunshade, diy, gardening, how to, outdoor living
I used the tee fitting to help support the tops of the arch. The tee fitting was placed onto the male ends and the cut pvc was used as the support beam to attach the two arches.
  • diy backyard sunshade, diy, gardening, how to, outdoor living
After we perfected the sturdiness of the arch, we used curtains as the shade. They’re not weather-proof, but since the pvc slides easily off of the rebar, the curtains can be removed during bad weather or replaced if damaged. The curtains also saved time because I didn’t have to do any sewing because the seams were already there.
  • diy backyard sunshade, diy, gardening, how to, outdoor living
I had to add a touch of beauty for my momma, so I took the pvc off the rebar and slid the terra cotta pots over the rebar. Then I put the pvc back onto the rebar. All I had left to do was add a little soil and flowers to the pot and voila! My mom has her own little sitting area in the shade to enjoy.
  • diy backyard sunshade, diy, gardening, how to, outdoor living